It will go out after I hit cancel or exit. The thing I do not understand is why the floppy light stays on after hitting F6 to load third party drivers. And both are seen by the BIOS, I disconnected the second SATA drive so there would be only one drive to be used at first. The DVD/ZIP drives are both set on an IDE cable. I have tried each of the settings like (Raid, AHCI and IDE) I did try the F9 set to default. The cable only connects one way, there is a notch one each side of the cable. I tried a known good floppy drive and then a good cable. Tried doing, I did most of what you replied with. I have used every thing on the MB we site and can not get to the drives even though the BIOS can see them. I tried booting in to the RAID section and selecting RAID, I just used one drive and using known good SATA cables. I have tried the F6 to load drivers I used both the blue cable and the black drivers. I checked the floppy disk on another computer and worked great, I used a known good floppy drive with the same results, I used another known good floppy drive cable. The provided Floppies did not work the floppy drive light was on after I hit F6 but not before. I booted to the XP Pro CD and no HD found, fine since it has SATA drives I will load the drivers with F6 at boot. The floppy drive light stayed on after I hit the F6 key. No problems with anything, BIOS found all drives and the other drives. I will post more if needed, install went great. Two used SATA 2/80 gig drives, a used DVD R/W drive, a used IDE zip drive, a floppy drive and a new P/S 800WT. It is a new MB, new Corsair memory (2 1gig DDR2), an Intel quad core CPU and fan. I have made a few computers in my time but this MB is a real pain in the rump! The table below lists parts that passed testing conducted using the IntelĀ® Self Test program for IntelĀ® Desktop Board D975XBX2.I have been given the task of installing a configuring this main board. These part numbers might not be readily available throughout the product life cycle. Memory listed completed testing by the memory vendor or by Intel using this test plan. Intel supplies the memory vendors that participate in this program with a common memory test plan to use as a basic checkout of the memory stability. Third-party tested memory occurs as requested by the memory vendors and is tested at an independent memory location that is not a part of Intel - Computer Memory Test Labs (CMTL). The table below lists the resulting working memory frequencies based on the combination of DIMMs and processors. For example, if DDR2 800 memory is used with a 533 MHz system Bus frequency processor, the memory works at 533 MHz. Regardless of the DIMM type used, the memory frequency is either equal to or less than the processor system Bus frequency. The following table lists the supported DIMM configurations. Performance and reliability can be impacted or the DIMMs might not function under the designated frequency. If non-SPD memory is installed, the BIOS tries to correctly configure the memory settings. This structure allows the BIOS to read the SPD data and program the chipset to accurately configure memory settings for optimum performance. To be fully compliant with applicable DDR SDRAM memory specifications, the board should have DIMMs supporting the Serial Presence Detect (SPD) data structure. Remove the Primary PCI Express* x16 (electrical x16 or x8) video card before installing or upgrading memory to avoid interference with the memory retention mechanism. DDR2 800, DDR2 667, and DDR2 533 MHz SDRAM DIMMs.Unbuffered, single-sided, or double-sided DIMMs with the following restriction: Double-sided DIMMs with x16 organization are not supported.The board has four DIMM sockets and supports the following memory features:
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |